Infrastructure
Multimode fiber (OM3, OM4, OM5) is common inside buildings and data centers over short distances. Single-mode fiber (OS2) is used for longer distances between buildings and in carrier networks. The installed fiber decides which transceivers will work.
Revised 2026-10-10. Published by Novatelia. No individual author is named, because no personal credential is claimed for this explanation.
Key points
- Multimode: larger core, short reach, often lower-cost optics.
- Single-mode: small core, long reach.
- Never mix the two types on one link.
Definition
Optical fiber carries light in a glass core. Multimode fiber has a 50 ?m core (OM3/OM4/OM5) and carries several light paths. Single-mode fiber has a core of about 9 ?m and carries one path, so the signal travels much further.
How it works
For 10G Ethernet, 10GBASE-SR on multimode reaches up to 300 m on OM3 and 400 m on OM4, while 10GBASE-LR on single-mode reaches 10 km. At 25G and 100G, short-reach distances on multimode fall to about 70 m (OM3) and 100 m (OM4). For a new backbone, many designs install single-mode because of its reach headroom.
Architecture
- Horizontal or in-rack: multimode patch cords and trunks.
- Building backbone: multimode or single-mode depending on length and speed.
- Campus and outside plant: single-mode.
Use cases
- Choosing fiber for a new data-center row.
- Checking whether an existing OM3 run can carry 25G.
- Planning a link between two buildings.
Comparison
- OM3 / OM4 / OM5
- Multimode; colour-coded jackets are common (aqua for OM3/OM4, lime for OM5), but check the cable print.
- OS2
- Single-mode; yellow jacket is common.
Selection guidance
- Measure the link length, including patch cords.
- Read the fiber type printed on the cable.
- Plan for the next speed step, not only today.
- Test new links with the appropriate fiber test equipment.
Questions
Can I use single-mode transceivers on multimode fiber?
No. The transceiver and the fiber type must match, and both ends must use the same standard.
Is OM4 worth it over OM3?
OM4 gives more reach at the same speed, for example 400 m vs 300 m for 10GBASE-SR. Whether that matters depends on your link lengths.
Related
More in Infrastructure
This page defines a term so a project can be scoped. It is not a certification, a test result, or a price. Partnerships are stated only on the partners page. The published address and telephone are the company contact, not a service-level commitment.
Describe the requirement
An RFQ saves a browser draft. It does not publish a price or issue a quotation reference.

